Luulisi että vika ei ole pyörän antureissa, kun ABS valo ei vilku. Kun nehän käyttävät samoja anturi tietoja.
Oliko auton vuosimalli 2001 ja koneena Y26SE? Alla olevat tiedot on katsottu kyseistä autoa ajatellen
Alla vikakuvauksia anturivioista
C0035 Front Left Wheel Sensor Open Circuit
Interruption in circuit to control unit terminal 6, 7
Above condition must be fulfilled for at least 0.2 s .
Effect:
The ABS function is locked.
The traction control function is locked.
C0035 Front Left Wheel Sensor Incorrect Signal
Incorrect signal from speed sensor
Vehicle speed is greater than 6 km/h (4 mph)
Above conditions must be fulfilled for at least 20 s .
Effect:
The ABS function is locked.
The traction control function is locked.
Alla vikakoodeja jotka aiheuttavat TC:n häiriön, mutta eivät ABS:n häiriötä.
C0236 No Engine Speed Signal
Short to voltage/ground or interruption in circuit to control unit terminal 30
Above conditions must be fulfilled for at least 1 s .
Effect:
The traction control function is locked.
Concerned Terminals: 30
C0241 Ignition / Injection Cutoff Bad Signal
Short to voltage/ground or interruption in circuit to control unit terminal 13
Above conditions must be fulfilled for at least 0.3 s .
Effect:
The traction control function is locked.
Concerned Terminals: 13
C0244 Throttle Position Sensor (TPS) Input No Signal
Short to voltage/ground or interruption in circuit to control unit terminal 27
or
Faulty signal from engine control unit
Engine Load Signal
Effect:
The traction control function is locked.
Concerned Terminals:27
Toivottavasti auttaa, eikä sötke lisää...
)
